Hello again, and welcome to my second tutorial for this site! I’m Iza, of Iza’s Face Ups, and this time I’m going to cover how I apply eyelashes to a doll once the face up is complete!

Things You Will Need:

  1. The doll’s head. In this case we have my Fairyland LTF Dark Elf Soo faceplate in tan skin.
  2. An eyelash strip. I used Onyx eyelashes I got off of Taobao in black. Any appropriate length eyelash strip will do, as we’ll cut the it to the right width!
  3. White glue. In my case I use straight up PVA glue.
  4. A pin. Anyone with a sewing kit should have one. Doesn’t need to be fancy or anything, just any old pin will do!
  5. Small scissors.
  6. (Optional) Tweezers. I use these to place the eyelashes as I have unsteady hands.

Now that we got our supplies all assembled, let’s start with the preparations and get to applying some eyelashes!

Step 1:

Measure the eyelash strip against the eye, that way you’ll know how to cut it.

Step 2:

Cut the eyelash to the appropriate width. If it still ends up being too wide, don’t fret. We can always trim it later too.

Step 3:

Put a dollop of glue onto a piece of paper, the eyelash holder, etc… and then grab your pin and dip it in the glue. You won’t need much really at a time. Also don’t fret about the glue being white, it’ll dry clear.

Step 4:

Use the pin to apply the glue from the outer corner of the eye to the middle point along the inner edge of the eyelid. Do to same to the eyelash piece and let the glue get a little tacky. This is important and will save you a lot of grief in trying to get the eyelashes to stay where you want them to. I like to put the long lashes on to outer edge and the shorter ones towards the inner corner.

Step 5:

Place the eyelash strip against the inner eyelid edge and use the pin to push it in place. The tackiness of the glue will keep it from falling out. If it tries to fall off regardless, hold the eyelash strip in place with the pin for a minute.

Step 6:

While the glue is drying on the first eye, repeat the process on the second eye. That gives the glue time to set on the first eye so that you can then glue in the other half of the eyelashes. Here you can also see that the eyelash strip on the right is a little too long. Trim it very carefully with the scissors so that it’ll fit better.

Step 7:

Grab a bit of glue with the pin again and apply it to the remaining section of the inner eyelid edge on the first eye. Let it get a little tacky.

Step 8:

Push the second half of the eyelash strip in place and let the glue dry. Repeat the process for the second eye so that both have the eyelashes in place.

Step 9:

Once the eyelashes are in place, I like to add another light layer of glue along the bottom of the eyelash strip as shown in the image ago. It creates a nice sealed bond so the eyelash is less likely to separate from the eye by accident.

Step 10:

Let the glue fully dry, and then wait a little more, just to make sure. I tend to leave heads alone for at least an hour after gluing in eyelashes to make sure that when I put the eyes in they don’t push the eyelashes out. As you can see the glue dried clear.

Congratulations, you successfully applied eyelashes to a doll head! I wish you much success on your face up journey; until next time!

Places to find me:

Website
Flickr
Instagram
Tumblr

Responses

Your email address will not be published. Required fields are marked *

+